29
8.5. Disassembly of ALLPLAY
Module Block
• Refer to “Disassembly of Top Cabinet”
Step 1 : Remove 2 screws.
Step 2 : Push inwards Dipole Antenna.
Step 3 : Remove 2 screws.
Step 4 : Detach antenna wire at connector (J2) on ALLPLAY
Module with Data.
Step 5 : Remove screw.
Step 6 : Detach 20P FFC at connector (J22) on ALLPLAY
Module with Data.
Step 7 : Detach 30P FFC at connector (J23) on ALLPLAY
Module with Data..
Step 8 : Release guide.
Step 9 : Lift up and remove ALLPLAY Module Block.
To Next Page
Loading...
