11
7 Disassembly and Assembly Instructions
Caution Note:
• This section describes the disassembly and/or assembly procedures for all major printed circuit boards & main components for
the unit. (You may refer to the section of “Main components and P.C.B Locations” as described in the service manual)
• Before carrying out the disassembly process, please ensure all the safety precautions & procedures are followed.
• During the disassembly and/or assembly process, please handle with care as there may be chassis components with
sharp edges.
• Avoid touching heatsinks due to its high temperature after prolong use. (See caution as described below)
• During disassembly and assembly, please ensure proper service tools, equipments or jigs is being used.
• During replacement of component parts, please refer to the section of “Replacement Parts List” as described in the
service manual.
• Select items from the following indexes when disassembly or replacement are required.
• Disassembly of Side Panel Unit
• Disassembly of Passive Radiator
• Disassembly of Woofer Speaker (SP61)
• Disassembly of Amp Module Assembly
• Disassembly of AC Inlet P.C.B.
• Disassembly of SMPS Module P.C.B.
• Disassembly of Digital Receiver (RX) Module P.C.B.
• Disassembly of ID Switch P.C.B. and D-Amp P.C.B.
• Replacement of Switch Regulator IC (IC5200)
To Next Page
Loading...
