13
7.3. Disassembly of Side Panel Unit
Step 1 : Peel off the screw covers by using the pen knife.
Caution : Place it in original location during assembling.
Step 2 : Remove 4 screws.
Step 3 : Insert the flathead screwdriver into the gap of the Side
Panel Unit.
Step 4 : Lift up the Side Panel Unit slightly.
Step 5 : Insert two flathead screwdriver at the gap and apply
force to gently push out the Side Panel Unit as shown.
Caution : Do not exert too much force as it may damage
the Side Panel Unit.
To Next Page
Loading...
