17
7.7. Disassembly of AC Inlet P.C.B.
• Refer to “Disassembly of Amp Module Assembly”.
Step 1 : Detach the 2P Wire of the connector (CN101) on
SMPS Module P.C.B..
Step 2 : Remove the AC Inlet P.C.B. as arrow shown.
7.8. Disassembly of SMPS Module
P.C.B.
• Refer to “Disassembly of Amp Module Assembly”.
• Refer to (Step 1) of “Disassembly of AC Inlet P.C.B.”.
Step 1 : Detach the 7P Cable Wire of the connector (CN201)
on SMPS Module P.C.B..
Step 2 : Remove 3 screws.
To Next Page
Loading...
