16
7.6. Disassembly of Amp Module
Assembly
Step 1 : Remove 1 screw.
Step 2 : Remove 6 screws.
Step 3 : Lift down slightly the Amp Module Assembly as arrow
shown.
Caution : Do not exert too much force as it may damage
the wiring within.
Step 4 : Detach the 2P Wire of the connector (CN1005) on D-
Amp P.C.B..
Step 5 : Detach the 5P Cable Wire of the connector (CN1003)
on D-Amp P.C.B..
Step 6 : Remove the Amp Module Assembly as arrow shown.
To Next Page
Loading...
