19
7.10. Disassembly of ID Switch
P.C.B. and D-Amp P.C.B.
• Refer to “Disassembly of Amp Module Assembly”.
• Refer to (Step 1) of “Disassembly of SMPS Module P.C.B.”.
Step 1 : Remove 1 screw.
Step 2 : Remove ID Switch P.C.B. as arrow shown.
Caution : During assembling, ensure the ID Switch P.C.B.
is seated properly onto the locators.
Step 3 : Remove 4 screws.
Step 4 : Remove D-Amp P.C.B. as arrow shown.
Caution : During assembling, ensure the D-Amp P.C.B.
is seated properly onto the locators.
To Next Page
Loading...
