Panasonic SC-PM03

TUNE MODE
(P_f?j5£''0
QlRtiMO
With preset stations
Preset channel
With non-preset stations
Received frequency
Numeric buttons
TUNER/BAND
ooc
ooooll
FM MODE
C
r / /
go.
Listening to radio broadcasts
H Press TUNER/BAND to select “FM” or “AM”.
The power will come on automatically.
Every time you press the button;
n Press TUNE MODE to select “PRESET” or
“MANUAL”.
Every time you press the button; “MANUAL''^—^‘'PRESET’.
PRESET: For preset stations
MANUAL: For non-preset stations
Q Press —or to select the
desired broadcast.
“STEREO’’ lights when an FM stereo broadcast Is being
received. “TUNED" lights when you precisely tune in a station.
Q Adjust the volume.
One-touch play
When the system is OFF, the broadcast station last tuned will be
received automatically when you press TUNER/BAND.
Aufo tuning
Auto tuning is an easy way to tune in non-preset stations (select
“MANUAL" in step Q).
Hold down either or and release
the button when the frequency starts scrolling.
The radio frequency will stop automatically on the first station it picks
up. When there is outside interference, the radio may stop on a non¬
broadcast frequency.
Hold down either or to resume auto tuning.
To stop auto tuning
Press either or -•-/ ► ► / ► ► i again.
Selecting channels with the remote control El
If you preset stations in memory, you can tune in a preset station by
simply selecting the preset channel with the numeric buttons on the
remote control.
1. Press TUNER/BAND on the remote control.
2. Press TUNER/BAND to select “FM" or “AM".
3. Press the numeric button(s) to select the desired preset channel.
To select a two-digit channel
Press >10 and then the two numbers you want within 10 second
or so.
If noise is excessive in fhe FM stereo mode B
by remote control only
Press FM MODE. (“MONO" will light up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. “MONO" will go out.
For your reference
You can preset FM stations in monaural. Make sure “MONO” lights
up. Then follow “Presetting only your favourite stations” on page 10 to
preset FM stations in monaural.
Normally, you’ll want to listen in stereo, so leave “MONO" off. This
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono.
11
ROT5462
Radio
operations