Panasonic SC-PM03

Connections
Baste connections
(for supplied accessories)
• Plug the AC power supply corid into a household AC outlet only after
all other connections have been made.
•To prepare the AM loop antenna wire and speaker cords, twist the
vinyl cover tip and pull oft.
• For your listening pleasure, keep your speakers from touching the
system.
•Speakers are designed identically so that no left or right channel
orientation is necessary.
n Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position where radio
signals are received with the least amount of interference.
For best reception sound quality;
An FM outdoor antenna is recommended. (See page 7.)
Q Connect the AM loop antenna.
After attaching the antenna, turn on the system and tune in a
broadcast station. Put the antenna where reception is best and
interference is minimal.
Q Connect the right (R) and left (L) speaker
cables.
• Keep your speakers at least 10 mm (^ 3 / 32 ") away from the sys¬
tem for proper ventilation,
•To prevent damage to circuitry, never short-circuit positive (-I-)
and negative (-) speaker wires.
• Be sure to connect only positive (red) wires to positive (- 1 -) ter¬
minals and negative (black) wires to negative (-) terminals.
Q Connect the AC power supply cord.
The included AC power supply cord is for use with this unit only.
Do not use it with other equipment.
Caution
• Use the speakers only with the recommended
system. Failure to do so may lead to damage
to the amplifier and/or the speakers, and may
result in the risk of fire. Consult a qualified
service person if damage has occurred or if
you experience a sudden change in per¬
formance.
• Do not attach these speakers to walls or
ceilings.