Panasonic SC-PM10 User Manual

RQT6682
11
Listening operations
The radio: preset tuning
by remote control only
There are two methods of presetting stations.
Automatic presetting: All the stations the tuner can
receive are preset.
Manual presetting: You can select the stations to
preset and the order they are
preset in.
Up to 15 stations each can be set in the FM and AM bands.
Preparation:
Press [TUNER/BAND] to select “FM” or “AM”.
A Automatic presetting
Do the following once each for FM and AM.
Preparation:
Tune to the frequency where presetting is to begin (\ page 10).
Press and hold [PROGRAM/–CLEAR].
The tuner presets all the stations it can receive into the
channels in ascending order. When finished, the last station
memorized is tuned in.
Manual presetting
Preset the stations one at a time.
1 Press [PROGRAM/–CLEAR] then press
[g, REW/
44
44
4] or [f,
33
33
3 /FF] to tune to the
required station.
2 Press [PROGRAM/–CLEAR] then press
[g, REW/
44
44
4] or [f,
33
33
3 /FF] to select a
channel.
3 Press [PROGRAM/–CLEAR].
The station occupying a channel is erased if another station
is preset in that channel.
B Selecting channels
1 Press the numbered buttons to select the
channel.
For channels 1 to 9 press the corresponding number.
For channels 10 to 15 press [
10], then the two digits.
OR
1 Press [TUNE MODE] to select
“
PROGRAM
”.
2 Press [g, REW/
44
44
4] or [f,
33
33
3 /FF] to
select the channel.
2 Adjust the volume.
Allocation setting
Each country allocates broadcast bands according to their
particular needs.
This system can also receive AM broadcasts allocated in 10
kHz steps.
To change the step (9kHz ↔ 10kHz)
Preparation:
Press [TUNER/BAND] to select “FM”.
1 Press and hold [TUNER/BAND].
After a few seconds the display changes to a flashing
display of the current minimum frequency.
2 Continue to hold [TUNER/BAND] down.
When the minimum frequency changes, release the
button.
To return to the original step, repeat the above steps.
Note
• After changing the “allocation” setting, the frequencies you
previously preset in the memory will be cleared.
A
B
1
2
TUNER/
BAND
PROGRAM/
CLEAR
/
REW
,
,
,
/FF
123
45
6
789
0
10
VOL VOL
REW
FF FM MODE
DIMMERDIMMERDISPLAYMUMUTINGING
BASS
TREBLE
PLAY
SLEEP
TIMERTIMER
CLOCK
REC
EQ
VIRTUALIZER
SOUND
PRESET
TUNE MODE
CD RECCD REC
MODE
CD PLACD PLAY
MODE
PROGRAM/PROGRAM/
CLEAR
TAPEAPE
TUNER
BAND
CD
STOP
123
45
6
789
0
10
VOL VOL
REW
FF FM MODE
DIMMERDIMMERDISPLAYMUMUTINGING
BASS
TREBLE
PLAY
SLEEP
TIMERTIMER
CLOCK
REC
EQ
VIRTUALIZER
SOUND
PRESET
TUNE MODE
CD RECCD REC
MODE
CD PLACD PLAY
MODE
PROGRAM/PROGRAM/
CLEAR
TAPEAPE
TUNER
BAND
CD
STOP
1
2
2
1
123
45
6
789
0
10
VOL
VOL
PROGRAM/
CLEAR
MHz
PROGRAM
PROGRAM
PROGRAM
PROGRAM
Preset channel
RQT6682(11-24)NEW1.P653/24/05, 3:45 PM11

Panasonic SC-PM10 Specifications

Amplifier Section

FTC power output	14W per channel (6 Ω)
RMS power output	15W per channel (6 Ω)
Output impedance - Headphone	16-32 Ω

FM Tuner Section

Frequency range (200 kHz steps)	87.9–107.9 MHz
Frequency range (100 kHz steps)	87.5–108.0 MHz
Sensitivity	2.0 µV (IHF)

AM Tuner Section

Frequency range	520 – 1710 kHz (10 kHz steps)
Sensitivity S/N 20 dB (at 1000 kHz)	560 µV/m

Cassette Deck Section

Tape speed	4.8 cm/s
Wow and flutter	0.15% (WRMS)
Fast forward and rewind time	Approx. 120 seconds with C-60 cassette tape

CD Section

Sampling frequency	44.1 kHz
Beam source/wavelength	Semiconductor laser/780 nm
Wow and flutter	Below measurable limit

Speaker Section

Speaker full range	10 cm (4˝) cone type
Tweeter	6 cm (2 [3]/8˝) cone type
Dimensions (WxHxD)	140 x 225 x 228 mm

General

Power supply	AC 120 V, 60 Hz
Power consumption	38 W
Dimensions (WxHxD)	165 x 228 x 313 mm