Panasonic SC-PM10 User Manual

RQT6682
17
Listening operations
Recording CDs
Normal recording
• Tracks are recorded in the order in which they are found
on the CD.
• Tracks are cut in the middle when the end of the tape is
reached.
• You can record from any point on the tape.
1 Insert the cassette to be recorded on.
(\ page 15)
2 Press [STOP L] to select the CD mode.
3 Press [OPEN/CLOSE c] to open the CD tray.
Insert the CD with label facing upward.
Press [OPEN/CLOSE
cc
cc
c] to close the CD tray.
4 Press [[REC/ J ] to start recording.
The recording will start from the first track.
To stop recording
Press [STOP L].
The recording and the CD will stop.
To stop recording temporarily
Press [[REC/ J].
To resume recording, press [[REC/ J].
To record from a specific point on a tape
Before recording, advance the tape to the point from where
you want to start recording.
To record programmed tracks
1 After step 3, program the track(s) you want (\ steps 2-4
on page 14).
2 Press [[REC/ J] to start recording.
2
3
4
4
2
3
STOP
OPEN CLOSE
REC
Recording operations
REC
RQT6682(11-24)NEW.P65 3/24/05, 12:06 PM17

Panasonic SC-PM10 Specifications

Amplifier Section

FTC power output	14W per channel (6 Ω)
RMS power output	15W per channel (6 Ω)
Output impedance - Headphone	16-32 Ω

FM Tuner Section

Frequency range (200 kHz steps)	87.9–107.9 MHz
Frequency range (100 kHz steps)	87.5–108.0 MHz
Sensitivity	2.0 µV (IHF)

AM Tuner Section

Frequency range	520 – 1710 kHz (10 kHz steps)
Sensitivity S/N 20 dB (at 1000 kHz)	560 µV/m

Cassette Deck Section

Tape speed	4.8 cm/s
Wow and flutter	0.15% (WRMS)
Fast forward and rewind time	Approx. 120 seconds with C-60 cassette tape

CD Section

Sampling frequency	44.1 kHz
Beam source/wavelength	Semiconductor laser/780 nm
Wow and flutter	Below measurable limit

Speaker Section

Speaker full range	10 cm (4˝) cone type
Tweeter	6 cm (2 [3]/8˝) cone type
Dimensions (WxHxD)	140 x 225 x 228 mm

General

Power supply	AC 120 V, 60 Hz
Power consumption	38 W
Dimensions (WxHxD)	165 x 228 x 313 mm