8
VQT4L45
Preparation
Install and replace the
batteries of remote control
Speaker connections
- Risk of explosion! Keep battery(ies) away from
heat, sunshine or fi re. Never discard the battery
in fi re.
- Install the batteries so that the poles (+ and -)
align with those in the remote control.
- Point the remote control at the remote control
sensor, away from obstacles, at a maximum
range of 7 m directly in front of the main unit.
- If you are not going to use the remote control
for a long time, remove the batteries.
Use only the supplied speakers
The combination of the main unit and speakers
give the best sound. If you use other speakers,
the system may be damaged and the sound
quality may be decreased.
Note:
- Put the speakers on a fl at safe surface.
- These speakers do not have magnetic shielding.
Do not put them near PCs or other equipment
easily infl uenced by magnetism.
- When playing at high levels for a long period, it
may cause damage to the system and decrease
the life of the system.
- Decrease the volume in following conditions to
prevent damage:
- When playing the distorted sound.
- When adjusting the sound quality.
- Connect only speakers with the same or
higher impedance. Refer to “Specifi cations” for
details.
- When connecting the speakers, make sure that
“+” and “-” polarities are matched properly.
Red wire
(+)
Black wire
-
R6/LR6, AA
2
1
Information on Disposal in other
Countries outside the European
Union
This symbol is only valid in the
European Union.
If you wish to discard this
product, please contact your
local authorities or dealer and
ask for the correct method of
disposal.
- If you see this symbol -
To Next Page
Loading...
