Panasonic SDR-S10P - Page 105

Others
Problem I Check points
This unit cannot be
operated though it
is turnedon .. c
This unit does not
operate normally.
The screen has
•. changed suddenly ..
A function
indication such as
the remaining time
indication or the··
elapsed
time
indication is not'
shown.
• The unit cannot be operated unless you open the LCD
monitor.
• Remove the SO card then press the RESET button.
(~ 109) If normal conditions are not restored yet,
remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then
about 1 minute later, turn on the power again.
(Conducting the above operation when the access
lamp is on may destroy the data on the card.)
• Has
the demonstration started?
~ If you set [DEMO MODE] to [ON] without inserting a
card
in video recording mode or picture recording
mode, the unit is automatically set to the demonstration
mode for introducing its functions. Normally this should
be set to [OFF]. Press the MENU button, then select
[SETUP]
~ [DEMO MODE] ~ [OFF] and press the
cursor button
in the center.
• If you set [SETUP]~[OISPLAY]~[OFF], indications
other than warnings and date indications disappear.
. .... ,r;,"c w •w •
••.. ,.,.-.-- •••• W •••.S •• l •• ,.,'.V., ... ),) ••••
105
VQT1D97