Panasonic SDR-S10P - Operating Instructions; Verifying that the Unit Is Correctly Recognized by the Computer

With a computer
Verifying that the unit
is correctly recognized
by the computer
To verify if this unit is correctly
recognized by the computer, turn on this
units power and then connect the unit to
the computer with a USB cable and
follow the steps below.
• With some computers including those
made by NEC, the Device Manager
may not be displayed if a mode that
places restrictions
on the functions has
been established. Consult the
manufacturer or follow the steps
in
your computer's operating instructions
to establish a mode
in which all the
functions can be used, then proceed
with operation.
1 Select [start] ~ ([Settings] ~)
[Control Panel] ~
([Performance and
Maintenance]
~ ) [System].
2 Click the [Hardware] tab, then
click [Device Manager].
>< •• .,....... ... ""'-
J.jt ~~:.~=: .... __ ......... _'m
3 Verify the following items are
displayed.
~':;<' ;-.: ~ .-:Ji :-.~-·""·'._:.f·.-· " ,.- - ,~.-.-.w.~ u.~ , .•... ,- .. ; ..•..•..
·r!;;~···························
.-'i' __ '
,.:;;.. .... "<"<~ .. , ... -
~:~~==~.:...
;fS::-'-*--
tI~~:
;ll~~~ .
• If the driver has been
recognized properly
[USB Mass Storage Device] appears at
[Universal Serial Bus controllers].
• If the driver has not been
recognized properly
[I] or [Unknown device] appears at
[Universal Serial Bus controllers] or
[Other devices], etc.
(Where the display will appear depends
on the type
of computer you are using.)
You can use the following methods to
enable the driver to be recognized.
Method
1: Turn off the unit and your
computer once and try
verifying again.
Method
2: Remove the SD card and try
verifying again.
Method
3: Try connecting the unit to
another USB port on your
computer.
··.··w·n.·.··n····
. u ··.-.··~·~·,",.w.w.-.-.,·. ,.-- u·.-.-.---.-- .. ··•· " ..., .. '"'_ w,._ w.,.· .• , ~.'."-l~·.
90
VQT1D97