Others
• When the LCD monitor gets dirty, wipe
it with a dry soft cloth.
• In a place with drastic temperature
changes, condensation may form on
the LCD monitor. Wipe it with a soft dry
cloth.
• When the unit has become very cold,
for example due to storage
in
a cold
area, its LCD monitor will be slightly
darkerthan usual immediately afterthe
power is turned on. The normal
brightness will be restored when the
unit's internal temperature rises.
Extremely high precision technology
is
employed to produce the LCD
Monitor screen featuring a total
of
approximately 123,000 pixels. The
result is more than 99.99% effective
pixels with a mere
0.01
%
of
the pixels
inactive or always lit. However, this is
not a malfunction and does not affect
the recorded picture.
.·Aboutcondensati.or"':
If condensation forms on the unit, the
lens will cloud up, the
SO
card may be
damaged and the unit may not work
properly. Make every effort to ensure that
condensation does not form.
If
it does
form, take the actions described below.
• Causes
of
condensation
Condensation
takes place when
the
ambient
temperature
or
humidity
is
changed as
follows
.
• When this unit is brought inside from
the cold (e.g. a ski slope) to a warm
room.
• When this unit is moved from an
air-conditioned car to outside.
• When a cold room has been warmed
up quickly.
• When cool wind from an air conditioner
is directly blown onto this unit.
• After summer afternoon rain showers.
• When this unit is
in
a very humid place
where the air is thick with steam. (e.g.
a heated swimming pool)
When
this
unit
is
taken
to
a
location
with
a
significant
temperature
difference
such
as
from
a
cold
place
to
a
hot
place.
If, for example, you have used this unit
for recording
on
a ski slope and are
taking it into a heated room, place the
unit inside a plastic bag, remove as
much
of
the air from inside the bag as
possible, then seal the bag. Leave the
unit for about an hour
in
the room so the
temperature
of
the unit is close to the
ambient temperature
of
the room, then
use
it.
•
What
to
do
if
the
lens
is
fogged
up.
Remove the battery or AC adaptor and
leave the unit for about 1 hour with the
card/battery door open. When the unit
becomes close to the ambient
temperature
I the fog disappears
naturally.
.
···
..
r
,
..
r··_·'···r-··--··_··_r
_
..
~w
.•...•.•.
, 't?l?K·w'
w.-'
.
.
......
·
....
·
..
·"
..
·w
.........
··rTf'·."'
..
··
114
VQT1D97
To Next Page
Loading...
