EasyManua.ls Logo

Panasonic SDR-S10P - Page 25

Panasonic SDR-S10P
147 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Setup
4
Connect
the
AC
adaptor
(supplied)
0
to
this
unit
and
the
AC outlet.
Slide the terminal cover lock
to
OPEN
and
then open the terminal cover.
f.) Connect the AC cable to the AC
adaptor, then the AC outlet.
e Connect the AC adaptor to this unit's
DC input terminal.
The status indicator
CD
starts
blinking in red at intervals of about
2 seconds to signal that charging
has commenced. Charging is
completed when the lamp goes off.
The output plug
of
the AC cable is
not completely connected to the
AC adaptor jack. As shown
in
S,
there is a gap.
Do not use the AC cable with any
other equipment as it is designed
only for this unit. Do not use an AC
cable from other equipment with
this unit.
Battery charging time
(~
27)
We recommend using Panasonic
batteries. (VW-VBJ10)
If you use other batteries, we cannot
guarantee the quality
of
this product.
CAUTION
Danger
of
explosion
if
battery is
incorrectly replaced. Replace only
with the same
or
equivalent type
recommended by the manufacturer.
Dispose of used batteries according
to the manufacturer's instructions.
About
charging
errors
When
the
status
indicator
flashes
rapidly
or
slowly,
one
of
the
following
situations
may
be
to
blame.
When
the
status
indicator
flashes
at
intervals
of
about
6
seconds
(on
for
about
3 sec. and
off
for
about
3 sec.):
The battery may have excessively
discharged. It can be recharged but
in
some cases it may take several hours
until regular charging commences.
The battery temperature or the
ambient temperature may be
extremely high or low and charging
may take time.
When
the
status
indicator
flashes
at
intervals
of
about
0.5
second
(on
for
about
0.25 sec.
and
off
for
about
0.25
sec.):
The battery has not been recharged.
Remove the battery from the unit, and
try charging it again.
The battery temperature or ambient
temperature may be extremely high or
low. Wait until the appropriate
temperature is restored before
charging the battery again. If the
battery still fails to charge, something
may be wrong with the unit, battery, AC
adaptor etc. Contact your dealer.
25
VQT1D97

Table of Contents

Related product manuals