Panasonic SDR-S10P - Page 30

Setup
3 Open the LCD monitor.
• Quick start standby mode is canceled,
the status indicator goes off and the
power turns off
in the following cases.
-When the mode dial is switched.
• When this unit
is quick-started with the
white balance on automatic, it may
take some time until the white balance
is adjusted if the scene being recorded
has a light source different from the
scene last recorded. (When the
MagicPix function
is used, however,
the white balance of the scene last
recorded is retained.)
• When this unit is quick-started, the
zoom magnification becomes 1
x and
the view may differ from what it was
before quick start standby mode.
• If [POWER SAVE] is set to
[5 MINUTES] and the unit
automatically goes into quick start
standby mode, close the LCD monitor
and then open it again.
2 Close the LCD monitor while
the mode dial
is set to • or
O·
~ .... -
The status indicator 0 flashes green and
the unit goes into quick start standby
mode.
The status indicator
0 lights red and the
unit is put into recording pause approx.
1.7 seconds after it
is turned on.
To cancel Quick start
Press the MENU button then [SETUP]
~ [QUICK START] ~ [OFF] and then
press the cursor button
in the center.
• The status indicator goes off and the
power turns off ifthe mode dial is set to
OFF while the unit is in quick start
standby mode.
• The status indicator goes off and the
power turns off
if quick start standby
mode continues for approx. 5 minutes.
'w· .• ··•··.· ••• ·.···....... ......• 'TTWM •. w.w.w.
30
VQT1D97