Panasonic SDR-S10P - Page 81

With other products
8 Select the paper size setting
on [PAPER SIZE].
u~n ~
~~ ~ ~ 9:;:;:~:»::4i[0~ !~~2:<~~:' ~::{I
[STANDARD]: Size specific to the
printer
[4X5 INCH]: L size
[5X7 INCH]: 2L size
[4X6 INCH]: Postcard size
[A4]: A4 size
•
You cannot set paper sizes not
supported on the printer.
9 Select the layout setting on
[PAGE LAYOUT].
[STANDARD]: Layout specific to the
printer
[0]: No frame print
lIf Ill: Frame print
•
You cannot set page layouts not
supported on the printer.
10Select [PRINT] ~ [YES] and
then press the cursor button
in the center.
The pictures are printed.
• Exit PictBridge by disconnecting
the USB cable after the pictures
have been printed.
When you want to stop printing
halfway
Press the cursor button down.
A confirmation message appears. If
[YES] is selected, the number
of prints
set is canceled and the screen returns to
step 4. If [NO] is selected, all the settings
are kept and the screen returns to
step
4.
• Avoid the following operations during
printing. These operations disable
proper printing.
- Disconnecting the USB cable
- Opening the card/battery door
- Switching the mode dial
- Turning off the power
• Check the settings for the paper size,
quality
of print, etc. on the printer.
•
You may not be able to print still
pictures recorded with other products.
• When the unit is connected directly to
the printer, the DPOF settings cannot
be used.
• Connect the printer directly to this unit.
Do not use a USB hub.
""T'"''
.. . .. , '§'" ," t", ro'.' · .. '.·,w.·.·.w._.·,·.'.·.',,· ' w ' .. ,w·· ,'.· ","" ..
81
VQT1D97