Panasonic TH-152UX1 - Removal of HX-Board; Removal of A-Board; Removal of DS-Board; Removal of CJ(C1)-Board

31
TH-152UX1 / TH-152UX1W / TH-152UX1C
3. Remove 4 screws and then remove DN-Board.
9.5. Removal of HX-Board
1. Remove 4 screws and then remove the Slot Fixed
plate(Upper).
2. Disconnect the connector (HX1).
3. Remove Hexagonal-Head 2 screws and 1 screw then
remove HX-Board.
9.6. Removal of A-Board
1. Remove the Slot Fixed Plate (Upper) and HX-Board.
(Refer to Removal of HX-Board)
2. Disconnect the connectors (A3, A6, A7, A8, A9, A14,
A22, A33, A44).
3. Remove the flexible cables from the connectors (A1, A10,
A16).
4. Remove Hexagonal-Head 2 screws.
5. Remove 4 screws ( ).
6. Remove 2 screws ( ) and then remove the A-Board.
Note:
A re-setup of the destination is performed by MS
mode after A-Board exchange.
9.7. Removal of DS-Board
1. Remove the Slot Fixed Plate (Upper) and HX-Board.
(Refer to Removal of HX-Board)
2. Remove 1 screw and then remove the Slot Fixed plate
(Middle).
3. Disconnect the connector (DS44).
4. Remove the flexible cable from the connector (DS1).
5. Remove 2 screws and then remove DS-Board.
9.8. Removal of CJ(C1)-Board
1. Remove each 2 screws and then remove the Heatsink.
2. Remove the flexible cable from the connector (C10CJ)