Panasonic TH-152UX1 - Removal of CA(C1)-Board

44
TH-152UX1 / TH-152UX1W / TH-152UX1C
-Remove Front End Fan Block and removal of Fan
Unit
a. Remove the Front End Block.
(Refer to Removal of Front End Block)
b. Remove the Top Panel.
(Refer to Removal of Exterior Board)
c. Remove each 4 screws and then remove the Fan Top
Side Cover.
d. Disconnect the Fan Realy Connectors.
e. Remove each 4 screws with placing the nut by needle
nose pliers.
f. Remove the Fan Unit (80).
2. Reassemble the Fans in reverse order.
3. Stick the Fan Sponge around the Fan.
Note:
The Fan Sponge is not re-usable.
Please use a new one when Fan exchange.
9.45. Removal of CA(C1)-Board
1. Remove the Fan Block A and B.
(Refer to Removal of Fan)
2. Remove each 2 screws and then remove the Heatsink.
3. Remove the flexible cable from the connector (C10CA).