Cable Connection
Program Out Connection (PROG OUT)
To use the television audio and video with optional equipment, connect the PROG OUT and TO AUDIO AMP connections
on the back of the television.
CONNECTIONS ON BACK OF TV
VCR
OR
MONITOR
L (_ _i_i _
SVIDEO _ _COMPONENT VIDEO INPUT 1_ ]_1 .F INPUTs2 " I Y 8 0g.NTI SpLfT ANT2
....UI
.....®®®® ®_'_
TO UFuDLo® ® ® ® ® ®L 4
,_,®®®® ® ®._0,o
---12Procedure
• Connect optional equipment to PROG OUT and TO AUDIO AMP terminals.
• PROG OUT terminal display is the same as onscreen display.
]
See optional equipment manual for further instructions for recording and monitoring.
How to connect the DIGITAL IN Terminals
Connecting a Digital Set ,Top - Box to DIGITAL IN
When connecting a Digital Set -Top -Box to DIGITAL-IN, be sure not to select "SKIP" from the INPUT LABEL menu. Failing
to do so may result in a distorted display or black out (refer to page 37).
DIGITAL IN (DVI) terminals
DIGITAL IN (DVl) cable
(Not supplied)
Digital Set-Top-Box
Audio
COMPONEN_ VIOEO INPUT
r INPU3"_ I
® ® ®
I
,oA_o_o®®®®® _® _-
A_®®® ® ® ®_A°°*z--I
/
2 x RCA plug
By inputting a High-bandwidth Digital Content Protection (HDCP) high-definition picture source to the DIGITAL IN terminal
of this television, high-definition pictures can be displayed on the screen in their digital form, (This DVI input terminal is
compliant with the EIA-861 standard and is not intended for use with personal computers.)
Note:
The DIGITAL IN terminal can only be used with 1080i, 480i or 480p picture signals. Set the Digital Set -Top -Box DIGITAL OUT
terminal Output setting to 108Oi,480i or 480p. For detailed information, refer to the Digital Set -Top - Box instruction manual. If
you cannot display the picture because your Digital Set -Top - Box does not have a DIGITAL OUT terminal Output setting, use
the component Video Input (or the S Video Input or Video Input). In this case the picture will be displayed as an analog signal.
17
To Next Page
Loading...
