VHF, UHF and Cable TV
Cable TV
When the antenna cable is connected to the TV antenna terminal via a cable box or VCR, set the TV channel to CH3 or CH4.
This does not apply when signal is input from VIDEO INPUT.
SAP
EXIT PAGE GUIDE
O_D_O
® ® ®
® ® ®
® ® ®
R-TUNE PROG
o ® ®
pip MIN pip MAX
REW pLAy FF
r_q CEC3 r;q
PAUSE STOP REC
r_ r_m r_
FREEZE pIp OH SEARCH
TVNCR VCR CH OPEn,CLOSE
O (£) G:) (£)
PIP SPLff MOVE SWAP
OOOO
Panasonic
Ferrite core (large size)
ANTENNA TERMINAL ON / (supplied)
THE BACKOF THE TV /
, : / To Antenna
_ I_=,_ _ Input
""1 _ I,1_ I_ IncomingCablefromAntenna
._,' '_-_ ,_ or CableTV System.
Less than w_ w_
4" (10 cm) (_ (_
OUTPUT INPUT
CABLE BOX
Confirming
Confirm that registration with cable TV provider and connection of
equipment are completed. Turn the CABLE BOX on and select the
desired volume level.
Press _ to confirm.
2
Press while pointing the remote control towards
the CABLE BOX.
Note:
The remote control code number is set for
Panasonic products.
When peripheral equipment does not operate,
reset code (See page 57 - 58).
3 Operate the CABLE BOX and select the desired volume level.
21
To Next Page
Loading...
