I Operatingperipheralequipmentusing I
theremotecontrol
ProgrammingThe IlluminatedRemoteControl UsingAccess Codes
The Universal Remote Control can be programmed to operate many manufacturers' components, using the component
function buttons for VCR, DVD, AUX, RCVR, TV, DTV CABLE or DBS. Follow the procedures for programming your
Remote Control with or without a code for the component.
Determine the manufacturer of the component and look in the table for the code.
1 Confirm that the external component is plugged in and operating.
2 Turn the component off.
3
4-
Press POWER and ACTION together, for at least 5 seconds.
After 5 seconds, all the illuminated mode keys will begin to flash.
Release the POWER and ACTION keys.
Press the mode key.
The mode key will illuminate steadily, all others will go out.
s ®® ®
lee el
6
Enter the 3-digit component code using the Remote Control numeric keypad.
Press the Remote Control
the component will turn on.
totest the component. If the procedure is successful,
Default Modes For Remote Control
TV TV (Panasonic Only) Panasonic TV Codes
DTM DTV (Panasonic Only) Panasonic DTV Codes
CABL I= CABLE (Preset) Panasonic CABLE Codes
DBS DBS (Preset) Panasonic DBS Codes
MCR VCR (Preset) Panasonic VCR Codes
DVD and CD (Preset) Panasonic DVD Codes
Personal Video Recorders, Panasonic Personal Video
Tape and VCR2 Recorders Code
Audio Receiver (Preset) Panasonic RCVR Code
If the component does not operate with the Remote Control, repeat the
procedure using another code. (Some brands have multiple codes).
If an incorrect code is entered, or if the procedure takes longer than 30
seconds,the programming will fail.
57
To Next Page
Loading...
