Operating peripheral equipment using the remote control
Programming Without A Code (When the code is not known)
This procedure searches all codes and is called the "sequence method."
1 Confirm that the external component is plugged in and on.
2 Turn the component off.
Press POWER and ACTION together, for at least 5
seconds.
After 5 seconds, all the illuminated mode keys will
begin to flash.
Release the POWER and ACTION key.
EXIT PAGE GUIDE
O (_b G) O
® ®1
®®®1
pIp MIN PIP MAX
REW PLAY FF
PAUSE STOP REC
rm_r_
FREEZE pip CH SEARCH
TVNCR VCR CH OPEN/CLOSE
O (2:) G:) (_
PIP SPLIT MOVE SWAP
OOOO
I_ana,_mrd¢
[_ % Press the mode key.
4 _ _ _ The mode key will illuminate steadily, all others will go
O %ou,
Press to move forward to the next code, or to move
backward.
6
Press the Remote Control, _to test the component. If the procedure was
successful, the component will turn on.
Note:
Repeat the above steps until the component code is found. It may take many
attempts before the correct code is found.
7
After the code is found, press ACTION to store the code.
Note:
The step and set mode willstart from the current device (not the beginning of the
list,except for the first time).
58
To Next Page
Loading...
