1/2
Signal
Screensaver
Extended life settings
Off
Off
Off
Enable
OSD Language English
(
UK
)
Component/RGB-in select
RGB
Power save
Setup
Input label
Disable
PC Power management
No signal power off
No activity power off
DVI-D Power management
Express settings
Custom settings
Reset
Extended life settings
30
Picture Mode
Contrast
Extended life settings
Dynamic
Side panel
NANODRIFT Saver
Lock settings
Peak limit
High
Mid
unlock
Apply to current input
Apply to all inputs
Off
Recommended settings
28
Extended life settings
Side panel
Do not display a picture in 4:3 mode for an extended period,
as this can cause an image retention to remain on the side
panels on either side of the display fi eld.
To reduce the risk of such an image retention, illuminate
the side panels.
This function may be applicable to the non-picture area.
Off: Darken both ends.
Low: Make it dark gray.
Mid: Make it gray.
High: Make it light gray.
Notes:
• To reduce the occurrence of image retention, set the Side panel to High.
• The side panel may fl ash (alternate black/white) depending on the picture being shown on the screen. Using Cinema
mode will reduce such fl ashing.
side panel
4:3 Screen
Display
image
retention
Reduces screen image retention
The following settings are setup to reduce image retention:
Image Retention Reduction Menu
“Extended life settings” enables you to set the following 5 menus (Image Retention Reduction Menu) as recommended
values or set them individually.
Picture Mode
Contrast
“Picture Mode” and “Contrast” are same as “Picture” menu items (see page 23). The settings of this menu will be
refl ected to the “Picture” menu.
Set to the recommended value
Set individually
Reset to the factory settings
Image Retention Reduction
Menu
To Next Page
Loading...
