21
TH-58PF12UK
9 Disassembly and Assem-
bly Instructions
• To disassemble P.C.B., wait for 1 minute after power was off
for discharge from electrolysis capacitors.
• , , and marks indicate screw positions.
9.1. Removal of Rear Cover
1. Remove screws (×12 , ×27 ) and then remove the
Rear Cover.
Note: when fixing the Rear Cover
• Screw on screws (*1) firstly by lifting the bottom of the
Rear Cover.
9.2. Removal of HHH-Board
1. Remove 4 screws (A) and then remove the HHH Terminal
Block.
2. Remove 4 screws (B).
3. Remove 4 screws (C) and then remove HHH-Board.
9.3. Removal of HA-Board
1. Remove 4 screws (D) and then remove the HA Terminal
Block.
2. Remove 4 screws (E).
3. Remove 3 screws (F) and then remove HA-Board.
9.4. Removal of Slot Block
1. Remove the flexible cables from the connectors (DS1,
DS3).
2. Disconnect the connectors (DS2, DS4, DS6, DS7, DS8,
DS15).
3. Remove 6 screws and then remove the Slot Block.
To Next Page
Loading...
