Panasonic TH-58PF12UK - Removal of DN-Board; Removal of D-Board; Removal of P(MULTI)-Board; Removal of P(SUS)-Board

23
TH-58PF12UK
9.8. Removal of DN-Board
1. Remove the flexible cables from the connectors (DN1,
DN2).
2. Disconnect the connectors (DN3, DN5, DN9).
3. Remove 4 screws and then remove DN-Board .
Note:
A re-setup of the destination is performed by MS
mode after DN-Board exchange.
9.9. Removal of D-Board
1. Remove the Slot Block.
(Refer to Removal of Slot Block)
2. Disconnect the connectors (D3, D5, D25).
3. Remove the flexible cables from the connectors (D20,
D31, D32).
4. Remove 4 screws and then remove D-Board.
9.10. Removal of P(MULTI)-Board
1. Disconnect the connectors (P6, P7 P9, P25, P34, P35,
P52, P53, P55).
2. Remove 9 screws and then remove P(MULTI)-Board.
9.11. Removal of P(SUS)-Board
1. Disconnect the connectors (P2, P11 P51, P54, P56).
2. Remove 6 screws and then remove P(SUS)-Board.