28
TH-58PF12UK
4. Pull the bottom of the Plasma Display Panel forward
(arrow1).
5. Slide the Plasma Display Panel and then remove the
Plasma Display Panel (arrow2).
9.23.1. Removal of Front Glass
1. Remove 25 screws and then remove the Fixed Angles
(left, right, upper, bottom).
2. Remove the Front Glass.
Note: when Front Glass is exchanged
• Paste the Front Glass Sponge in order along each Fixed
Angles left and right, upper and bottom.
Note
• The Front Glass Sponges are parts which cannot be
recycled. Please use the new article when you exchange
the Front Glass.
9.23.2. Removal of V2-Board
1. Remove 20 screws and then remove the Fixed Angles
(left, right, bottom).
2. Remove 2 hooks and then remove the 5 Key Button from
V2-Board.
3. Disconnect the connector (V15) and then remove V2-
Board.
9.23.3. Removal of Cabinet Assy
1. Remove the Front Glass.
(Refer to Removal of Front Glass)
2. Remove V2-Board.
(Refer to Removal of V2-Board)
3. Remove V1-Board.
(Refer to Removal of V1-Board)
4. Remove the LED Panel and Remote Sensor Panel.
5. Remove the Cabinet Assy.
To Next Page
Loading...
