76 77
Others / 其他
Specifications
Model TK-AS45 TK-AS41 TK-AS40
Rating 220 V – 240 V
, 50 Hz, 0.3 A
Power consumption Approx. 55 W (approx. 1 W during standby)
Main unit
Dimensions 170 mm (W) × 101 mm (D) × 291 mm (H)
Weight Approx. 3.0 kg (approx. 3.5 kg when full of water)
Temperature of water used by Alkaline Ionizer Under 35 °C (under 80 °C for bypass selector)
Pressure of water used by Alkaline Ionizer
(dynamic pressure)
70 kPa to 350 kPa
Usable water service pressure (static pressure) 70 kPa to 750 kPa
Electrolysis
Electrolysis method Continuous electrolysis
Output water volume
(flow of water produced)
2.0 liters/min. (at 100 kPa water pressure)
3.0 liters/min. (at 200 kPa water pressure)
Electrolytic capability selection Alkaline: 3 levels; Acidic: 1 level
Continuous operation capability Approx. 30 minutes at room temperature (Note 2)
Electrolyzer life
Approx. 850 hours cumulative (ion water production time, cleaning time
only)
Electrolytic cleaning
Auto cleaning method (cleaning time: approx. 8 seconds, waste water
drain time: approx. 30 seconds)
Purified water output volume 2.0 liters/minute (at 100 kPa water pressure)
Filtration flow volume 2.5 liters/minute (at 100 kPa water pressure)
Cartridge installed in the main unit TK-AS45C1-EX TK7815C1ZEX TK7505C1ZEX
Purification
capacity
(Note 1)
Free residual chlorine 12 000 liters (Note 3) 12 000 liters (Note 3)
Turbidity 12 000 liters (Note 4) 12 000 liters (Note 4)
Total trihalomethane 12 000 liters (Note 3) 12 000 liters (Note 3)
Chloroform 12 000 liters (Note 3) —
Bromodichloromethane 12 000 liters (Note 3) —
Dibromochloromethane 12 000 liters (Note 3) —
Bromoform 12 000 liters (Note 3) —
Tetrachloroethylene 12 000 liters (Note 3) —
Trichloroethylene 12 000 liters (Note 3) —
1,1,1-Tr i c hloro e t h a ne 12 000 liters (Note 3) —
CAT 12 000 liters (Note 3) —
2-MIB (mold smell) 12 000 liters (Note 3) 12 000 liters (Note 3)
Soluble lead 12 000 liters (Note 3) 12 000 liters (Note 3)
Substances other than above that can be
removed
Iron (particulate form)
(Note 5)
—
Aluminum (neutral)
(Note 5)
—
Geosmin (mold smell)
12 000 liters (Note 5)
—
Phenols
12 000 liters (Note 5)
—
Guide for time to replace cartridge Approx. 1 year (Note 6)
Filter material
Non-woven fabric, granular activated carbon, ceramic, powdered
activated carbon, hollow fiber membrane
Components which cannot be filtered out Iron dissolved in water, heavy metals (silver, copper, etc.), salt (seawater)
Length of power cord Approx. 3 m
Power protection device Current fuse: 2.5 A
Overheating protection devices
(inside isolation transformer)
Overheating protector (automatic resetting type, activated at temperature
of 120 °C)
Thermal fuse (activated at temperature of 145 °C)
※ All figures given are for a water temperature of 20 °C.
※ This product cannot convert hard water into soft water.
※ The total volume of water coming out of the main spout and drain hose is given as the run-through
water volume and daily volume of water used.
Note 1: The water which can be used as alkaline ion water and acidic water is equivalent to about
80% of the filtration flow volume.
Note 2: This period may be shorter depending on the water quality and usage environment.
Note 3: This value is for a removal rate of 80% based on JIS S 3201 tests.
Note 4: This value is for a filtration flow volume of 50% based on JIS S 3201 tests.
Note 5: This value is for a removal rate of 80% based on specification standard tests (JWPAS B
standards) stipulated by the Japan Water Purifier Association (JWPA).
Note that the removal of iron (particulate form) and aluminum (neutral) are not stipulated as
part of purification capacity.
Note 6: This period applies when 30 liters of water are used a day. If 60 liters are used a day, the
cartridge usage limit will be approximately one-half. The period may also be significantly less
depending on the amount of water used and on its quality and pressure.
To Next Page
Loading...
