14 15
Introduction / 前言
Supplied Accessories/配件
Before using the Alkaline Ionizer, check that the following supplied accessories are accounted for. If
any are missing, contact your dealer.
使用前請先查看下列的配件。若有品項不齊時，請向購買經銷商索取。
For Use in Attaching
the Bypass Selector
分水開關安裝用
For Use in Installing the Main Unit
本體安裝用
Consumables
消耗品
Bypass Selector
分水開關
Installation Adaptor
(with 4 screws)
安裝轉接器
（附 有 四 個 螺 絲）
Bushing
(with gasket)
密封套
（附 有 墊 片）
Hose Strap
軟管固定綁帶
With gasket
附有墊片
Outlet Pipe
出水管
Suction Disc
(for drain hose)
吸盤
（排 水管 用）
Caution Label
注意標籤
pH Test Kit
pH值測試液
Names of the Parts and Steps to Take Before Operation
Cap
Outlet pipe
(length: approx. 40 cm)
Water supply hose
(length: approx. 90 cm)
Faucet
(not included)
Hose strap
Main unit
Power plug
Drain hose
(length: approx. 60 cm)
Power cord
(length: approx. 3 m)
Suction disc
Main spout
Bypass selector
Control panel
P. 3 4
Steps to take before operation
1
Checking the faucet
P. 1 7
2
Attaching the bypass selector
P. 18 – 22
3
Installing the Alkaline Ionizer
P. 23 – 25
4
Checks after installation
P. 28 – 29
Run purified water through the Alkaline
Ionizer for about 3 or 4 minutes
(to expel the air inside the main unit)
OThe water quality indicator lamp blinks
for about 10 seconds – 40 seconds.
5
Measuring the pH level
(ion concentration)
P. 30, 31
Operation
P. 36 – 39
To Next Page
Loading...
