37
Set the bypass selector to “Unpurified” or “Shower”.
[Bypass selector as seen from below]
Using the unpurified water (tap water) By “unpurified water” is meant here the untreated tap water.
The table on the right shows the temperatures
at which water can be used by the Alkaline
Ionizer. Use water at these temperatures
(otherwise trouble may result).
Important
Bypass selector
The water comes straight out. The water comes out as a shower.
Shut off the hot water immediately, and
run about 0.4 liter of cool water (for
about 10 seconds) through the Alkaline
Ionizer to cool it down.
Water will still come out of the hot
water opening for a few moments: this
is normal and does not indicate any
trouble.
The hot water guard mechanism is
activated (at temperatures over 60°C) to
protect the cartridge.
A beep may be heard at this time: this is
normal and does not indicate any trouble.
If hot water has been run through
the Alkaline Ionizer by mistake, it will
come out of the hot water opening.
Unpurified water
shower holes
Source water
opening (straight)
Hot water opening
Position of bypass selector Water temperature
Purifi ed Under 35°C
Unpurifi ed
Under 80°C
Shower
ZGS0TK7585HKE0Z.indb 37ZGS0TK7585HKE0Z.indb 37 2009/12/09 9:50:342009/12/09 9:50:34
To Next Page
Loading...
