81
Troubleshooting
The “Preparation time”
display blinks
This display appears for about 20 seconds when water runs
through the Alkaline Ionizer immediately after installation or
cartridge replacement.
The air inside the cartridge is being expelled. Keep running
the water for 3 or 4 minutes.
9
65
Ș When the LCD display shows the following:
The display changes to
“Alkaline” after “Alkaline 4
(Strongly Alkaline)”, “Weak
Acidic” or “Purified Water”
was used
When the faucet is turned off after the Alkaline Ionizer is
used at the “Alkaline 4 (Strongly Alkaline)”, “Weak Acidic” or
“Purified Water” setting, the “Alkaline” setting is automatically
restored.
This is not a malfunction.
35
The display does not return
to “Alkaline” after the
Alkaline Ionizer was used at
the “Purified Water” setting
Has “OFF” been selected for “Alkaline priority” so that the
Alkaline setting will not be returned?
Set “Alkaline priority” to ON.
Does this happen while the Continue lamp is lighted?
This is not a malfunction. The “Alkaline” setting will be
returned after about 10 minutes.
56
35
If you think that something is wrong with the Alkaline Ionizer, check out the following points before requesting
repairs. If you decide that trouble has occurred, do NOT attempt to disassemble and repair the Alkaline Ionizer
yourself, but contact your dealer.
Ʃ
Sometimes suspected trouble is remedied by disconnecting the power plug and then re-connecting it.
67
The “Electrode cleaning”
display blinks
Has the Alkaline Ionizer not been used for over 24 hours?
(The buzzer beeps for 3 seconds.)
The electrodes are being automatically cleaned. Keep
running the water for about 15 seconds.
No display at all or LCD
display is cleared suddenly
31
—
The display is cleared automatically when the Alkaline Ionizer
is not being used.
This is not a malfunction.
Ʃ
The LCD display is also cleared if no buttons are operated
for two minutes or more in the setting mode or check
mode. In this case, the settings or checks are aborted so
perform the operation again from the start.
Is the power plug disconnected?
If it is, connect it.
Cause and remedial actionSymptom
Reference
page
Continued on next page
English is not displayed on
the LCD.
This is because the English display mode has not been
selected.
Take the steps to switch to the English display mode.
29
English is displayed on the
LCD.
This is because switching to the English display mode has
been undertaken.
Take the steps to switch the display language, and return
to the Chinese displays.
29
The displays in the setting
and check modes are not in
English.
The displays cannot be shown in English in the setting and
check modes.
This is not a malfunction.
29
ZGS0TK7585HKE0Z.indb 81ZGS0TK7585HKE0Z.indb 81 2009/12/09 9:51:192009/12/09 9:51:19
To Next Page
Loading...
