83
When water is run
through the Alkaline
Ionizer, the water that
comes out is warm
When water starts to run through the Alkaline Ionizer, water
which was kept at room temperature while no water was
flowing to the Alkaline Ionizer or water warmed by the heat
inside the Alkaline Ionizer may come out.
This is not a malfunction. Allow the water to keep flowing
to the Alkaline Ionizer.
—
The water produced
by the Alkaline
Ionizer has an odor or
unpleasant taste or is
turbid
The ability of the cartridge to remove odors, unpleasant
tastes and turbidity has deteriorated.
Replace the cartridge.
64 – 66
The buzzer does not
sound even when
using the “Weak
Acidic” setting
Has “OFF” been set for the “Weak acidic buzzer” setting?
If so, set “ON for “Weak acidic buzzer”.
55
Depending on the temperature conditions, water formed from
condensation may collect inside the unit.
This is not a malfunction.
19
Water comes out
from the bottom of
the unit
The pH level of weak
acidic water is neutral
If the pH level of weak acidic water is 6.5 or so, it may not be
possible to distinguish it from the pH 7 level (neutral) in the
pH measurement table.
Test the water coming out of the drain outlet while using
the “Weak Acidic” setting, and if it is 10 to 11, it means that
the pH level for weak acidic water is 6.5 or so.
—
The pH level of the
water produced by
the Alkaline Ionizer is
not within the rough
pH level range
The pH level may be a little high when a new cartridge is
used (for the first week or so).
This is not a malfunction. Measure the pH level again
after a week.
—
Cause and remedial actionSymptom
Reference
page
Other
Continued on next page
Very little or no water
is discharged from
the Alkaline Ionizer
Ʃ
“Flow reduced”,
“Too much
tightened at the
faucet?” or “Bent
hose?” displays
appear alternately.
Is the water pressure too low?
Open up the faucet all the way. Check the flow.
Has the flow at the faucet been reduced too much?
Open up the faucet.
Is the filter of the bypass selector clogged?
If it is, clean the filter.
Has the cartridge been installed properly?
If it has not, install it properly.
Has the water supply been cut off?
Wait until the water supply is restored.
Is the water supply hose bent or flattened?
If it is, straighten it out.
Ʃ
If the display appears again even after taking the above
action, the flow has diminished because of a clogged
cartridge or other such reason.
60, 61
68
—
64 – 66
20, 21
—
50
ZGS0TK7585HKE0Z.indb 83ZGS0TK7585HKE0Z.indb 83 2009/12/09 9:51:202009/12/09 9:51:20
To Next Page
Loading...
