Panasonic TX-86PW100A - Page 3

The RF (Aerial) Input impedance of this television Is 750. If your aerial lead is 3000 ribbon (two wires separated
by a flat piastic strip) you wiii require a 3000/750 Baiun in order to connect your aerial to the television.
To Antenna TX-86PW1OOA & TX-76PW1OOA
For your safety any externai aerial should be installed by a reputable qualified installer and should comply with
Australian Standard AS1417.1.
In New Zealand the Installation should comply with International Standard IEC597-1.1.
This television is designed for the Australian Standard Mains Voltage of 240V 50Hz and the New Zealand
Standard Mains Voltage of 230V 50Hz.
NOTE:
If the television is not going to be used for an extended period, remove the power plug from the wall outlet.
Turn on the Television
Push the Power Switch to turn the television / ■
ON. Sit back and enjoy your new Panasonic
rn- i
television.
3