Panasonic TX-86PW100A - Page 35

This remote control has been designed to work with a variety of VCRs, Laser Discs and DVD players. In order
for this to occur, the setting for the VCR, LD or DVD must be programmed into the Remote Control.
1. To set a VCR, slide the remote control VCR-LD/DVD switch to VCR.
To set a LD or DVD, slide the remote control VCR-LD/DVD switch4j to LD/DVD.
2. Push the remote control VCR - LD/DVD Power Button @ and keep it Pushed.
3. Enter the Manufacturer’s two-digit code number using the remote control Number Buttons (The codes
are shown below).
4. Push the STOPfH^ button .
5. Release the remote control VCR or LD/DVD Power button.
6. Check the operation of the VCR, LD or DVD. If it does not operate correctly, repeat steps 1 to 5 and use
an alternate code (If there is one).
VCR CODES
Manufacturer
Code
Manufacturer Code
Panasonic /
10,11, 12,13
NEC
40, 41,42, 43
National
ORION
45, 46
AIWA
15.16
Philips
50
FUJITSU
20
SANYO
55, 56, 57, 58
HITACHI
25, 26. 27
SHARP
60.61
JVC
30, 31,32
SONY
65,66,67
MITSUBISHI
35, 36
TOSHIBA
70,71
LD CODES
Manufacturer Code
Manufacturer Code
Panasonic 10,11,12.13
KENWOOD 15.16
PHILIPS 20
PIONEER 25
SAMSUNG 30
SHARP 35
SONY 40,41,42,43
DVD CODES
Manufacturer Code
Panasonic 70
NOTES:
1. If the batteries are removed from the remote control the Manufacturer’s codes are lost and must be
reprogrammed.
2. The list of manufacturer’s codes is given as a guideline only. Panasonic cannot guarantee that any
other manufacturer’s product will work with this remote control.