Panasonic TX-86PW100A - Page 45

Customer Information
Frequently Asked Questions
Some minor problems can be corrected very quickly and easily without the cost of i^i;^;i^' panasonic has a Customer
Care Centre that can answer most questions over the phone. Before you contact the Customer Care Centre with vour
question we have Included the most commonly asked questions. ^ Centre with your
Question:
Answer;
Question:
Answer;
Question:
Answer:
Question:
Answer;
Question:
Answer;
Question:
Answer:
Question:
Answer:
Question:
Answer:
Question:
Answer:
Question:
Answer:
Why are my channels on 1,2,3,4,57
Someone has performed an "Automatic Search” tune of your television. You will have to retune each channel
individually using the Manual Search Instructions on page 29. channel
How do I get Channel 10?
You have three methods of selecting Channel 10
' ■
2. You can press the 9 button followed by the channel up button (A ).
3. You can tune channel 10 into another position such as programme location 0.
My channel number is still on the screen. How do I turn it off?
If the channel number is a small green number on the top left of the screen, press the recallSbutlon on thP
How do I tune my stations?
S'eTstafion^29 for tuning
The autornatic search and the manual search each have specific uses. The reason for each is cleariv
described in .he booK. The reason ,ha, au.oma«o search is described n,s, Is because .htt .he S ^option on
Why does the screen turn blue?
1 ■ The television station may have stopped transmitting,
2. You may have selected a programme number Uiat has not yet been tuned
3. You may have been watching a videotape or DVD and it has stopped playinq
4. Your aerial connection may have come loose.
When I skip a station why is a picture still coming up when I press the number that
The Skip operation only works when you use the Channel Up (A) or Down ( V ) Buttons.
When I use the channel up or channel down why don’t I get all the channels?
Some of the channels may be "Skipped". See page 31.
Why doesn’t the channel change when I press the channel button?
The television might be switched to Teletext mode. It it has been switched to text mode for closed captions
in Tex, m^dltnSTstd -e
I turned my television to Standby with the remote control and then I turned it of, with the newer
ewdch. 1 turned the TV back on with the power switch but ifs still in Standby andTra^ flnTmy
remote control. How can I turn the TV back on? ^
Press the front panel Up (+ / A) or Down (- / V) button. See page 9.
the channel is on?
If the answer to your problem is not in this list, determine the symptoms and make a few simple checks as shown on the
next page. The location of the nearest service centre can be obtained from the Panasonic Culmer Ca ™ S" ^n
45