22 English22
About LAN Connection
Since this product is equipped with a network function, connecting the product to a network by wire or
wirelessly enables remote control of the product. The Internet needs be accessible from the connected
network in order to update the software of the receiver and transmitter.
■
Wired LAN connection
Receiver Receiver board
LAN terminal
LAN terminal
LAN cable (commercially available)
Hub or router
In the initial setup, connecting the LAN terminal of the receiver to the network allows the IP address
of the receiver to be automatically assigned by the router using the DHCP function. The assigned IP
address is displayed on the standby screen (page 25 ). To manage the receiver (TY-WPR1/TY-
WPR1W) / receiver board (TY-SB01WP), use this IP address for connection.
Note
• For LAN cable, use shielded cable, otherwise picture noise may be caused.
• Touching the LAN Terminal with a statically charged hand (body) may cause damage to the device
due to its discharge.
Do not touch the LAN Terminal or the metal part of the LAN cable.
■
Wireless LAN connection
Using the wireless function of the receiver (TY-WPR1/TY-WPR1W) / receiver board (TY-SB01WP)
enable the product to be connected to an external wireless access point or mobile wireless LAN
router (only for 5 GHz wireless LAN), and an external network or the Internet.
Make the connection setting in [Network Management] on the Web setting screen. (page 30)
Note
• Connecting to a network and display an image (mirroring) using the wireless LAN connection
function of this product increases the possibility of the image to be stuck or noise to be generated.
It is recommended that connecting to an external wireless LAN be restricted to the cases such as
execution of firmware update.
To Next Page
Loading...
