q Power cord
w Video output cable
e Enclosure
r Panning table
Rotate this table to adjust the panning
angle of the camera.
t Tilt adjusting table
Adjust the azimuth angle of the image.
y Tilting lock screw
Locks the tilt position.
u Panning lock screw
Fixes the panning table.
i Focus lock knob
Locks the focal point.
o Zoom lock knob
Locks the zoom point.
!0 Camera fixing screw
Fix the attachment on the camera body.
!1 Monitor output connector
Connect the monitor for adjustment to this
output connector.
!2 Right button [(RIGHT), FAR]
Moves the cursor to the right, selects the
mode and adjusts some levels.
!3 Left button [(LEFT), NEAR]
Moves the cursor to the left, selects the
mode and adjusts some levels.
!4 Up button [(UP)]
Moves the cursor upward and selects
items in the setup menu.
!5 Down button [(DOWN), ABF1]
Moves the cursor downward and selects
items in the setup menu. Refer to page 25
for further information about [ABF1].
!6 Setting button [(SET), ABF2/MENU]
Confirms the setting contents. Refer to
page 27 for further information about
[ABF2].
!7 Heater output connector
The cable of heater unit (option) is con-
nected to this connector. (+ page 32)
!8 ABF operation indicator
Indicates the status of ABF operation.
!9 Inner dome
To Next Page
Loading...
