Panasonic WV-CW504F

24
Adjust the camera
z
Be sure to view the monitor for adjustment when the camera angle is adjusted.
Connect the monitor for adjustment (e.g. a small LCD) to the monitor output connector, and
adjust the camera angle.
When determining the camera angle, repeat fine follow the adjusting procedure of q, w, and
e shown below.
q Loosen the panning lock screw and rotate the camera head horizontally to adjust panning,
and tighten the panning lock screw.
w Loosen the tilting lock screws and rotate the camera head vertically to adjust tilting, and
tighten the tilting lock screw.
e Rotate the tilt adjusting table, and adjust the azimuth angle of the image.
Important:
 • Thepanninglockscrewandthetiltinglockscrewshallbesecurelytightened.
(Recommended tightening torque: 0.59 N·m {0.44 lbf·ft})
Note:
 • ThevideooutputtotheBNCconnectorwillbeinterruptedwhileanadjustingmonitoriscon-
nected to the monitor output connector.
 • Atthesametimeforthepanandtiltadjustments,makefocusadjustmentsofStep2.
L
O
C
K
L
O
C
K
L
O
C
K
L
O
C
K
75 °
Tilting lock screw
Monitor output connector
(RCA)
Tilt adjusting table
Panning lock screw
Panning table