Panasonic WV-CW504F

28
Waterproof treatment for the cable joint sections
Adequate waterproof treatment is required for the cables when the camera with exposed cables is
installed by means of the mounting base WV-Q115 or it is installed under the eaves. The camera
body is waterproof, but the cable ends are not waterproof.
Be sure to use the supplied butyl tape at the connection parts of the power cord and video output
cable to apply waterproof treatment in the following procedure. Failure to observe this may cause
water leakage resulting in malfunction.
<How to wind the supplied butyl tape>
Stretch the tape by approx. twice (see the illustration below) and wind it around the cable. Insuffi-
cient tape stretch causes insufficient waterproofing.
Note:
 • Toinstallthisproductoutdoors,besuretowaterproofthecables.Thecamerabodyiswater-
proof (IEC IP66 or equivalent) only when installation specified in this document and appropriate
waterproofing are properly performed. The bracket is not waterproof.
 • Thecableshallbewoundwithbutyltapeinahalf-overlappingmanner.
When using power
cord
When using video output cable
Dobled length
Stretch the tape to about twice.