Panasonic WV-CW504F

15
Preparations
When installing the camera on a wall or a ceiling, there are two methods as specified below.
(+ Next page)
 • Usingatwo-gangjunctionbox
 • UsingthemountingbaseWV-Q115
Refer to all work related to the installation of this product to qualified service personnel or system
installer.
 • ThemountingbaseWV-Q115isoptionalforWV-CW504F,WV-CW504FK.Usethescrewssup-
plied with the camera mount bracket.
 • ThemountingbaseWV-Q115issuppliedwithWV-CW504S,WV-CW504SK.Use the screws
supplied with this product.
Important:
 • Preparethemounting screwaccordingto the material ofthe areawherethe cameraattach-
ment (accessory) is to be installed. In this case, wood screws and nails should not be used. For
mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for
securing.
(Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
 • Whenusingtheprovidedcameraattachment,makesurethateitherofthearrowmarksfaces
upward.
 • Requiredpull-outcapacityofasinglescrew/boltis196N{44.06lbf}ormore.
 • Ifaceilingboardsuchasplasterboardistooweaktosupportthetotalweight,theareashall
be sufficiently reinforced.
 • Whenusinganoptionalmountingbracket,refertotheoperatinginstructionsofthebracketin
use.
The mounting conditions of the camera mount bracket are described as follows:
Installation
place
Applicable mount
bracket
Recommended
screw
Number
of screw
Minimum pull-out
strength
(per 1 pc.)
Ceiling/wall (Two-gang junction box) M4 or equivalent 4 pcs. 196 N {44.06 lbf}
Ceiling/wall WV-Q115
(approx. 350 g {0.77 lbs})
M4 or equivalent 4 pcs. 196 N {44.06 lbf}
Ceiling WV-Q169
(approx. 700 g {1.55 lbs})
– – *
* Make sure that the installed mount bracket can support more than 5 times of the weight of the
camera.