Panasonic WV-CW504F - Using a Two-Gang Junction Box

16
Using a two-gang junction box
 • Whenthecameraisinstalledusingthetwo-gangjunctionbox,mountthecameraattachment
(accessory) to the embedded box installed on the wall or ceiling as a first step.
Note:
• For wall mounting:
Installation shall be performed in such a manner that "MTOP" of the camera attachment faces
upward.
• For ceiling mounting:
The front side (model number indication face) of the camera shall be aligned in the direction of
the arrow in "<FRONT" on the camera attachment.
Using the mounting base WV-Q115
 • WheninstallingthecamerawiththemountingbaseWV-Q115,attachthemountingbasetothe
wall or ceiling in the first place. (+ next page.)
Mount the camera attachment (accessory) by using the screws supplied with mounting brack-
et. (+ next page.)
(Recommended tightening torque: 0.78 N·m {0.58 lbf·ft})
Note:
 • When installing the camera on the wall or ceiling where cable holes are alreadyprovided, or
when installing the camera with exposed wiring, the mount bracket shall be used.
 • ThefemalescrewsforpipingconformtoANSINPSM(parallelpipethreads)3/4".
The female screws for piping shall be removed with a hexagon wrench.
 • Toconnectconduitfromthetop,refertopage29.
46 mm {1-13/16"}
83.5 mm {3-9/32"}
[Mounting position on wall or ceiling]
Camera attachment (accessory)
Two-gang junction box
FRONT
TOP
FRONT
TOP