Panasonic WV-CW504F

38
Troubleshooting
Before asking for repairs, check the symptoms with the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution in the
table or a problem is not described below.
Symptom Cause/solution
Reference
pages
No image displayed
•Arethepowercordandcoaxialcable
connected appropriately?
→ Check whether the connection is
appropriately established.
30
•Istheadjustingmonitorconnected?
→ Check whether connection is estab-
lished.
24
•Isthemonitorbrightnessappropriately
adjusted, or is the contrast appropriately
adjusted?
→ Check whether the monitor settings
are appropriate.
–
•Weretheshockabsorbersinthedome
cover already removed?
→ Confirm whether the shock absorbers
have been already removed.
–
Blurred image
•Isthedomecoverfreefromcontamina-
tion and/or flaws?
→ Check the dome cover.
–
•Isthefocusadjustedcorrectly?
→ Check if the focus is adjusted correct-
ly.
25
•Isthelensofthecamerasoiledwithdirt
or dust?
→ Check whether the lens of the camera
is clean.
–
Damaged power cord
sheathing
The power cord and connector is dam-
aged. Use of the damaged cord or con-
nector may cause electric shock or fire.
Turn off the power immediately and request
repair to your dealer.
–
Heated portion of power line
consisting of power cord
during use
Warmed power cord or loos-
ened connection by bending
or stretching during use