Panasonic WV-CW504F - Page 36

36
Screenshot 3
The selected setup screen in the setup menu
appears on the screen.
Note:
 • If the top screen of the setup menu is
called up with the operation buttons while
a camera image is displayed, the setup
mode is always "DISABLE" to prevent
operation errors. To configure the settings
in the setup menu, change the setup mode
to "ENABLE".
 • Thecursorisareverselyhighlightedpart.
**CAMERA SETUP**
SCENE1
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
Step 4
Perform the settings for each item.
 • Selectionofsettingitem:
Press the up or down button to move the
cursor.
 • Changeofsettings:
Press the right or left button.
 • Displayofadvancedsetupscreen:
Press the setting button when "O" is
attached to the target setting item.
 • Returntoprevioussetupscreen:
Move the cursor to "RET" and press the
setting button.
 • Returntothetopscreen:
Move the cursor to "TOP" and press the
setting button.
Step 5
To return to the camera image screen, move
the cursor to "END" and press the setting but-
ton.