Panasonic WV-S6130

20
When connecting to a network using a PoE hub
Before starting the installation, check the entire system configuration. The following illustration gives
a wiring example of how to connect the camera to the network via a PoE device (hub).
IMPORTANT:
• Use a switching hub or a router which is compliant with 10BASE-T/100BASE-TX.
• If a PoE hub is not used, each network camera must be connected to a 12 V DC power
supply.
• When using 12 V DC, power supply from a PoE hub or router is not required.
LOCK
OPEN
WV-S6130
Confirmation
monitor
PoE device (hub)
PC
Ethernet cable
(category 5e or better,
straight)
Powered speaker
Microphone
* Use an Ethernet cable (category
5e or better, cross) when directly
connecting the camera to a PC.
Ethernet cable
(category 5e or
better, straight)
Ethernet cable
(category 5e or better,
straight)
Powered speaker
Microphone Confirmation
monitor