29
Symptom Cause/solution
Reference
pages
Status indicator
lights red.
This indicator lights up red when data cannot be
saved on the SD memory card.
• Isn’t the write protect switch of the inserted SD mem-
ory card set to “LOCK”?
Unlock the write protect switch of the SD memory card.
• Hasn’t the inserted SD memory card been formatted
on a PC?
Use an SD memory card formatted on the camera.
Or install the software to format the SD memory card
on the PC.
Refer to our website
(https://security.panasonic.com/support/info/) for fur-
ther information about the supported software.
• Isn’t the inserted SD memory card faulty?
Replace the card with a normal one.
Operating
Instructions
(included in
the CD-ROM)
Audio input contains
noise.
• Check the following.
• Grounding of the camera, a switching hub or periph-
eral devices are not done.
• The camera is used near an electrical power line.
• The camera is used near a device which produces
strong magnetic field or radio waves (such as near a
TV/radio antenna, a motor of an air conditioning sys-
tem, a transformer, etc.)
When audio input still contains noise even after check-
ing the above possibilities, use a powered microphone
or connect audio output with low output impedance.
14
The image refresh
interval on the web
browser is longer or
the image is dis-
played intermittently.
• When using the camera with the high frame rate and
high image quality, the image update delays due to the
PC specifications. These cases may be improved by
using a PC with the following specifications.
CPU: Intel
®
Core
TM
i7 6700 or faster
Memory: 8 GB dual channel (4 GB×2) or more
【Example of using the camera in case that the image
refresh interval is longer or intermittent】
• Image capture size: 1920×1080, Frame rate: 60 fps,
Bit rate: 4096 kbps
To Next Page
Loading...
