To Next PageTo Next PageWhy does the live indicator light or blink orange on my Panasonic WV-SC384 Security Camera when I turn it on?
If the live indicator on your Panasonic Security Camera lights or blinks orange upon turning it on, make sure the LAN cable is properly connected. Also, verify that the hub or router you are using is functioning correctly. If the issue persists, try replacing the cable with a different one.
Why is the power not turned on in my Panasonic WV-SC384?
If your Panasonic Security Camera isn't powering on, ensure the power plug is firmly connected. Also, check that the connection is appropriately established. For PoE devices, refer to their operating instructions for guidance.
How to fix Panasonic Network cameras when I cannot access the camera?
Check if you are using the correct IP address by using the Windows command prompt to ping the camera's IP address. If that doesn't work, reboot the camera and change the IP address using the Panasonic IP setup software within 20 minutes of the restart. Alternatively, reboot the camera while holding the [INITIAL SET] button to reset the IP address to the default setting '192.168.0.10'. Ensure that the IP addresses of your PC and the camera are in the same class.
General| Camera Type | Network Camera |
|---|---|
| Lens Type | Motorized Zoom Lens |
| Video Compression | H.264, MPEG-4, JPEG |
| Frame Rate | 30 fps |
| Day/Night | Yes |
| Effective Pixels | 2.1 Megapixels |
| Resolution | 1920 x 1080 |
| Angle of View (Horizontal) | 91.2° - 31.5° |
| Pan Range | 360° |
| Power Supply | PoE (Power over Ethernet) |
| Operating Temperature | -10 °C to +50 °C |
| Image Sensor | 1/3" MOS Sensor |
