19
Symptom Cause/solution
Reference
pages
AF/SD ERROR indi-
cator lights red or
blinks red
• Isn’t the write protect switch of the inserted SD mem-
ory card set to “LOCK”?
Unlock the write protect switch of the SD memory
card.
• Hasn't the inserted SD memory card been formatted
on a PC?
Use an SD memory card formatted on the camera.
Or install the software to format the SD memory card
on the PC. Refer to our website
(http://security.panasonic.com/pss/security/support/
info.html) for further information about the supported
software.
• Isn't the inserted SD memory card faulty?
Replace the card with a normal one.
Operating
Instructions
(included in
the
CD-ROM)
Audio input contains
noise.
• Check the following.
• Grounding of the camera, a switching hub or
peripheral devices are not done.
• The camera is used near an electrical power line.
• The camera is used near a device which produces
strong magnetic field or radio waves (such as near
a TV/radio antenna, a motor of an air conditioning
system, a transformer, etc.)
When audio input still contains noise even after
checking the above possibilities, use a powered
microphone or connect audio output with low output
impedance.
Installation
Guide
To Next Page
