11 Configure the settings relating to images and
audio [Image/Audio]
The settings relating to JPEG and H.264 images such as the settings of image quality, audio, etc. can be
configured on this page.
The “Image/Audio” page has the [JPEG/H.264] tab, the [Image quality] tab, and the [Audio] tab.
11.1 Configure the settings relating to the image
capture mode [JPEG/H.264]
Click the [JPEG/H.264] tab on the “Image/Audio” page. (®page 38, page 40)
[Image capture mode]
Select an image capture mode from the following.
:
2 mega pixel [16:9]/2 mega pixel [4:3]/3 mega pixel [4:3]
*1
• Default: 2 mega pixel [16:9]
:
1.3 mega pixel [16:9]/1.3 mega pixel [4:3]
• Default: 1.3 mega pixel [4:3]
IMPORTANT
• The positions of areas may move out of alignment when the “Image capture mode” setting is changed
when the following area settings are configured. Therefore we recommend that you configure each
area setting after configuring the “Image capture mode”.
– mask area (®page 88)
– privacy zone (®page 93)
– VMD area (®page 111)
– VIQS area (®page 95)
– Cropping outlines (®page 122)
Note
• When “On” is selected for “VIQS” and the setting value for the aspect ratio is changed from “4:3” to
“16:9”, make sure that the VIQS setting value does not exceed the maximum designated range.
*1
Used by super resolution techniques.
72 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
