• Default: None (blank)
IMPORTANT
• When using the SNMP function, it is necessary to enter the community name. When no community
name is entered, the SNMP function will not work.
[System name]
Enter a system name to be used to manage the camera with the SNMP function.
• Available number of characters: 0 - 32 characters
• Default: None (blank)
[Location]
Enter the name of the location where the camera is installed.
• Available number of characters: 0 - 32 characters
• Default: None (blank)
[Contact]
Enter the E-mail address or the phone number of the SNMP manager.
• Available number of characters: 0 - 255 characters
• Default: None (blank)
16.2.8 Configure the Diffserv settings
The settings relating to Diffserv can be configured on this page. The Diffserv function can be used to set the
priority of image/audio data sent from routers.
The priority set to this function must match the DSCP value configured to the router.
When using the Diffserv function, contact the network administrator.
[DSCP(0-63)]
Enter the order of priority for packets.
• Available values: 0 - 63
• Default: 0
Operating Instructions 159
16 Configuring the network settings [Network]
To Next Page
Loading...
