Panasonic WV-SP105

16
Installation
Connect the safety wire
If an installation area has sufficient strength (☞ page 17), secure the provided safety wire to the
installation area.
If not, procure another wire that can substitute for the safety wire (accessory).
The following is an example of safety wire connection.
Important:
 • Besuretoinstallthesafetywire.Askyourdealerforinstallation.
 • Takecaresothatthecameradoesnotrollover.Donotremovethecamera cover film until the
installation is completed.
 • Whentherearsheet*comesoff,fitthesheetintotherearpanelofthecamera.(Therearsheet
is not stuck to the camera.)
Install on ceiling
Camera mount bracket (locally procured) and the safety wire (accessory) will be used for installa-
tion.
z Bend the ring part and the ring neck of the safety wire (accessory).
x Engage the safety wire (accessory) with the wire engaging hole.
Safety wire
(accessory)
q Pass the ring part of the
safety wire (accessory)
through the wire engag-
ing hole.
w Pass the other end of the
safety wire through the ring
part of the safety wire.
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
12V IN
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
12V IN
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
12V IN
* Rear sheet